Taber 1700 Rotary Abraser Experimental Grinding Wheel Installation Method

Taber 1700 Rotary Abraser is a single grinding wheel, suitable for wear resistance tests of leather, cloth, paint, paper, floor tiles, plywood, glass, plastic floor, natural rubber, and other materials.

Shanghai Qianshi Precision Electromechanical Technology Co., Ltd. was established in 2012, focusing on the research and development, design, and production of textile testing instruments, providing textile testing instruments and services for academic research units and testing institutions. Shanghai Qianshi is currently one of the most competitive and R&D-capable textile testing instrument manufacturers in China. The R&D team is composed of a group of experienced engineers. We are committed to serving customers wholeheartedly and striving to promote technological innovation in textile testing instruments.

Main parameters:

1. Test piece: outer diameter φ108mm, inner diameter φ6mm

   
   

2. Grinding wheel: φ2″(MAX.52mm)1/2″(W)

   
   

3. Grinding wheel center distance: 63.5mm

   
   

4. Grinding wheel and test piece center distance: 37~38mm

   
   

5. Rotation speed: 60/72 rpm

   
   

6. Load: 250g, 750g, 1000g

   
   

Applicable standards:

ASTM D1175, ASTM D1044, ASTM D4060, TAPPI T476, ISO 9352, ISO 5470-1, ASTM D3884, JIS K7204, JIS A1453, JIS K6902, JIS L1096, JIS K6964, DIN 52347, DIN 53109, DIN 53754, DIN 53799, etc.

Grinding wheel installation:

One of them is marked with "Left Hand This Side Out", and the other is marked with "Right Hand This Side Out". The purpose of this instruction is to ensure that the assembly position of the grinding wheel after use is consistent when it is removed and placed in the container and the next time it is used.

To install any grinding wheel, remove the knurled nut with an arrow on the nut from the grinding wheel shaft. The nut on the left-hand side of the grinding head is a left-hand thread nut, please remove it in a clockwise direction, and the nut on the right-hand side of the grinding head is a right-hand thread nut. Please remove it in a counterclockwise direction.

Clean any fine particles that may exist in the grinding wheel axis and flange to prevent the grinding wheel from shifting. Unscrew the screw, carefully slide the grinding wheel into the axis and tighten it properly by hand.

If you find that the grinding wheel shakes when you turn it lightly with your fingers, please remove it, check and clean the small foreign matter attached to the axis, and reinstall it. If the elastic grinding wheel shakes slightly after installation, you can press it toward the positioning guide rail with your fingers.

When you find that the bearing has abnormal conditions, such as radial eccentricity when turning the grinding wheel with your fingers, you must re-polish it with a 200-type polishing wheel.

2024-11-28 11:02