Site： Home > News and events 
AATCC Test Method 61-1996 for textile Fastness
This test evaluates colorfastness and staining potential of fabrics under accelerated wash condition that simulate five home washings. Five separate methods test different home washing conditions. Specimens can also be evaluated for abrasion resistance during laundering based on appearance.
How This Test Works:
Samples are washed under specified conditions to replicate 5 home washings. The samples are then evaluated for color change, staining, and abrasion. Conditions for the appropriate procedure are determined and preprogrammed into the Launder-O-Meter or later listed in Launder-O-Meter conditions.
Sample Preparation:
1. Cut a 6” by 2” sample, one sample per person.
2. Sew or staple multi-fiber test fabric along one edge of the technical face of the sample. Multifiber test fabric should run along the length of the sample. Set sample aside.
3. Add 150mL of water and 0.225g of detergent to each canister.
4. Add 50 steel balls into the canister.
5. Place black gasket into canister lid. Press Teflon liner into lid (liner will be slightly too large and should cup towards the outside of the cap). Close lid.
6. Clamp the canisters into the Launder-O-Meter. Evenly distribute them on each of four sides. If necessary, add more canisters to even out the number.
7. Star the rotor and run it for at least 2 minutes (until temperature reaches 49° C) to preheat the canisters and solution.
Loading the Launder-O-Meter:
1. With a row of specimens in the upright position, unclamp the cover of one canister, drop in a well-crumpled test specimen, and replace the cover.
2. Continue adding specimens to each canister in the row. When finished, re-clamp the row.
3. Manually turn rotor to new row. Repeat until all samples are loaded.
Rinsing, Extracting, and Drying：
1. Remove the canisters and empty the contents into beakers, keeping each specimen separate.
2. Rinse each test specimen three times, in beakers, in de-ionized water for one-minute periods with occasional stirring or hand squeezing.
3. Blot to remove excess water.
4. Dry the specimens in the oven (71° C/160° F).
5. Allow specimens to conditions at standard humidity and temperature for at least one hour before evaluating.
Preparation for Evaluation：
1. Trim off raveled yarns and lightly brush off any loose fiber and yarn on the fabric surfaces.
2. For pile fabric specimens, brush the pile in the required direction to restore them as nearly as possible to the same pile angel as the original control sample.
3. Specimens should be smoothed and flattened if necessary.
Color Change Evaluation：
1. Compare sample to control fabric.
2. Use the AATCC Gray Scale for Color Change to evaluate the results. All group members should help to rate each sample.
3. Keep sample. Color change will be quantitatively measured using spectrophotometer at a later date.
Staining Evaluation：
1. Compare sample to control fabric.
2. Use the AATCC Gray Scale for Staining. All group members should help to rate each sample.
2019-08-29 13:41
- Related News
Ozone Aging Test Chamber: Understanding Four Concentration Test Methods
How to properly maintain the horizontal and vertical combustion tester?
What you must know about the Xenon lamp aging test chamber filter
Application of Ventilation Aging Test Chamber on Polymer Materials
3 Tips for Purchasing Aging Test Chambers
Matters that must be avoided in the operation of the UV aging test chamber
How to use the UV aging test chamber lamp correctly?
Wire and cable test artifact - ozone aging test box
3 aging factors that must be simulated in the aging test box
The role of Burning Manikin System in the field of thermal protection