Taber Abrasion Resistance Tester in 3 Easy Steps

Taber Abrasion Resistance Tester is suitable for cloth, paper, paint, plywood, leather, floor tiles, glass, natural plastic, etc. The test method is that the rotating sample bears a pair of wear wheels and applies a specified load. When the sample rotates, the wear wheel is driven to wear the sample. The weight loss of wear is the difference between the weight of the sample before and after the test.

Taber Abrasion Resistance Tester in 3 Easy Steps:

1. Clamp the sample

Place the cut sample on the test bench according to the standard requirements. Keep the sample flat, tighten the compression nut and washer, and fasten the sample fixing ring with a hexagonal wrench.

2. Clamping wear wheel and weight

Install the pre-ground standard wear wheel on the front inner side of the balance arm and tighten the compression nut. Clamp the corresponding weight or balance weight according to the required pressure. According to the specifications of the wear wheels tested for different materials in the corresponding standards, install the wear wheels of the corresponding specifications.

3. Start

Turn on the power switch. Set a preset number of laps on the counter. Press the start button, the motor drives the turntable to start to rotate.

Precautions:

1. When the grinding wheel is ground to the sticker or the surface of the grinding wheel is uneven, it needs to be replaced.

2. Before measuring a sample, clean the grinding wheel with a brush.

QINSUN is a world-renowned manufacturer of Taber Abrasion Resistance Tester. Our customers are all over the world and have a good reputation. Welcome to order!

2022-04-14 15:48