Rubber and plastic tensile tester standards
The rubber plastic tensile tester is mainly used for testing the mechanical
properties of materials such as films, fibers, and paper, such as tension,
compression, and bending. It is a device used for testing the mechanical
properties of materials.
Applicable standards:
ASTM D5034, ASTM D2261, ASTM D434, GB/T3923, GB/T3917, GB/T13772,
FZ/T80007.1, ISO5081, DIN53859, DIN53858, BS3320, 4303, 2576, 2543
Widely applicable:
Thin film materials: used to test the elastic modulus, yield strength,
maximum tensile strength and other parameters of thin film materials, providing
important technical support for the research and production of thin film
materials.
Fiber materials: used to test the strength, elasticity and other parameters
of fiber materials, providing important technical support for the research and
production of fiber materials.
Paper material: used to test the tensile strength, compressive strength and
other parameters of paper, providing important technical support for the
research and production of paper.
Other materials: Suitable for testing the mechanical properties of various
materials, including plastics, rubber, metals, and other materials.
Main parameters:
1. Force measurement range: 100N, 2500N, 5000N, optional
2. Stretching speed: 2mm/min~1200mm/min, any
3. Return speed: 2mm/min~1000mm/min
4. Timed stretching: 20s ± 3s, 30s ± 5s optional
5. Zui large set stretching times: 99 times
6. Average number of groups: 2-30 times (longitudinal and latitudinal
averages can be calculated separately)
7. Extension range: The elongation rate can reach 350% at a spacing of
200mm
8. Spacing: Any adjustment between 25 and 500mm
2024-04-19 17:17